This section provides the wiring guide for connecting a 2.8inch TFT display based on ILI9341 to an ESP32 development board. The table below outlines the pin connections for the display and touch ...

Grbl is a no-compromise, high performance, low cost alternative to parallel-port-based motion control for CNC milling. This version of Grbl runs on an Arduino with a 328p processor (Uno, Duemilanove, ...

Here’s a fun build from [RootSaid] that is suitable for people just getting started with microcontrollers and robotics — an Arduino-controlled two-wheeled robot. The video assumes you already have one ...

本设计主要考虑到方便更换主控和简化设计，直接应用ESP32开发板（ESP32-DEVKIT-V1）直插主板和直插驱动器方式，方便DIY和更换烧掉的驱动器。 支持常用步进电机驱动模块，如A4988。 除了一般GRBL的功能外另添加两个按键（MACRO1、MACRO2）一键执行内存卡中脚本或Gcode ...

Abstract: I welcome you to the fourth issue of the IEEE Communications Surveys and Tutorials in 2021. This issue includes 23 papers covering different aspects of communication networks. In particular, ...

ESP-Scope is an open-source firmware transforming any ESP32 board into an oscilloscope using one of the ADC pins up to 83,333 Hz sample rate (on the ESP32-C6) and visualizing the results over Wi-Fi in ...